ENG
FIXING TO PARENTS' BED
1.
Open the velcro panel covering the tubing joint. Release the plastic joints from
the
tubing (fig 14) and partially remove the tubes. Once this operation has been
performed on both sides, lower the crib side panel and fit it to the base of the
crib
main body using snap button (fig 15).
WARNING! Use the crib with the tube lowered in co-sleeping mode only.
2.
Move the crib close to the parents bed and check the height of the crib
compared with the mattress of the bed (fig 16).
WARNING! The mattress of parent's bed shall be aligned to or over the height of
the drop side in the lowest position.
WARNING! In co-sleeping mode the 2 legs of the crib should always be adjusted
to the same height.
fig 15
fig 14
fig 13
4
5
1
3
2
fig 16
