x
IM 2558A-01EN
Safety Precautions
Manipulez avec précaution lors de la génération de tension élevée
• Le produit génère une tension élevée. Faites attention au choc électrique et à la décharge
électrique.
• Afin d'éviter tout choc électrique, retirer les bagues, les montres et autres accessoires
métalliques ainsi que les bijoux avant la mise en service.
Câblage correct
Cet équipement délivre une tension et une intensité élevées. Si vous ne raccordez pas
correctement les appareils, non seulement cela risque d’endommager l’équipement ou
l’appareil cible, mais en plus cela risque d’entraîner un choc électrique ou un incendie.
Branchez toujours les câbles en plomb correctement et vérifiez les points suivants.
Avant le sortie (avant la mise sous tension), vérifier que :
• Les câbles en plomb sont correctement raccordés aux bornes de sortie de l’équipement.
Les câbles de sortie de la tension n'ont pas été malencontreusement branchés sur les
bornes de courant.
Les câbles de sortie du courant n'ont pas été malencontreusement branchés sur les bornes
de tension.
• Les câbles ont été correctement branchés sur l’appareil voulu.
Vérifier qu’il n’y a pas de court-circuit entre les bornes de tension ou entre les câbles
raccordés aux bornes de tension.
• Les câbles ont été correctement branchés sur les bornes de courant.
• Il n’y a aucun problème avec les bornes d'entrée de courant et les bornes de sertissage,
comme par exemple une présence de corps étrangers.
Pendant la sortie (ne pas toucher les bornes ni les câbles branchés lorsque l’instrument est
sous tension), vérifier que :
• Il n’y a aucun problème avec les bornes d’entrée de courant et les bornes de sertissage,
comme par exemple une présence de corps étrangers.
• Les bornes d’entrée ne chauffent pas anormalement.
• Les câbles ont été correctement branchés sur les bornes de courant.
Les raccordements de bornes risquent de se détacher dans le temps. Le cas échéant,
une chaleur peut être générée suite aux changements de résistance au contact. Vérifiez
régulièrement que les câbles en plomb sont bien raccordés aux bornes. Éteignez bien à la
fois cet équipement et l’appareil cible avant de vérifier les raccordements.
Après la sortie (tout de suite après la mise hors tension)
Une fois une tension ou un courant obtenu(e), la tension peut rester un certain temps,
même après la mise hors tension. Cette tension résiduelle peut entraîner un choc
électrique. Ne touchez pas immédiatement les bornes après la mise hors tension. La durée
pendant laquelle le tension reste varie en fonction de l’appareil cible.
ATTENTION
Limitations relatives à l’environnement opérationnel
Ce produit est un produit de classe A (pour environnements industriels). L’utilisation de ce
produit dans un zone résidentielle peut entraîner une interférence radio que l’utilisateur sera
tenu de rectifier.