IM 12J05S01-01E
2-3
2. Installation and Wiring
2.2.1
Connecting Sensor Cable
(1) Loosen two screws which are at front of power supply unit and detach the cover.
(2) Pull the cable into the power supply unit from sensor cable inlet hole.
(3) Connect the sensor cable to the terminals.
After passing the cable through the nut, check the color on each core wire, then
connect each core wire to the corresponding terminal.
DO70G Wiring Diagram Example
DO402G
DOX10
Detail-1
Detail-2
DO70G
Detail-1(DO402G)
Detail-2(DOX10)
(Wiring color)
DO70G
Red
Clear
Green/Yellow
Green
White
DO402G (Terminal No.)
18
17
14
12
11
BROWN
BLUE
(Wiring color)
DO70G
+ BROWN
- BLUE
DOX10 (Terminal No.)
K9679AX
Connections of the sensor cable and DO402G terminals
are shown in the following table.
Connections of the sensor cable and DOX10 terminals
are shown in the following table.
Figure 2.4 Connecting Sensor Cable
(4) Mount the cable gland in the cable inlet hole.
Put the nut in place, and screw it onto the main body sufficiently. At this time,
loosen the packing gland so that the cable is not twisted. After fixing the main body,
tighten the packing gland to keep moisture out of the equipment. However if the
packing gland is screwed up too tight, the cable will be damaged.
Summary of Contents for DOX10
