13
IM 04L51B11-01EN
Start FieldMate according to step
in (2) Provisioning
(figure 9).
Figure 9
As shown in figure 10, the icon of the detected YTMX
appears in the Segment Viewer. Double-click the icon.
In the dialog box that appears (figure 11), select the
Load Default Data option, and then click OK to start
DTM Works.
Figure 10
Figure 11
Click Menu(Online), Device Configuration, AI1
Temp, and then Configure/Setup. Then, select the
Configuration tab (figure 12).
Figure 12
Under Block Mode, set Mode.Target to O/S. Set the
parameters according to table 5, “Device parameter
setting example,” and then click Download to device.
Next, under Block Mode, set Mode.Target to Auto.
Then click Download to device (figure 13).
Figure 13
Repeat steps
and
for AI2 Temp to AI8 Temp.
When you are finished, click the Connect/Disconnect
button of DTM Works, and close it.
Figure 14
When the message “Do you want to save DTM Data to
Database?” appears, click No.