8-32
IM 703155-01E
• Data Length (Eye Length)
You can set the number of data points at which the waveform data is turned over and
overlaid.
Selectable range: 0 to 1024 points (in 1 point steps)
Default value: 4 points
• Display Begin and End Points (Begin Point and End Point)
You can set the points in the following range.
Selectable range: 0 to 1999999 points (in 1 point steps)
Be sure that (display end point – display start point) is greater than 0.
Default values: Begin Point: 0 point, End Point: 256 point
• Horizontal Axis Auto Scale (X Axis Auto Scale)
The horizontal scale is set so that all of the data points of the waveform data fit on the
waveform display frame.
Y Axis Mag.
Eye Length
1.5
–1.5
–4.0
4.0
Display example when
Y Axis Mag. = 1.5
Y Position = 0
Eye Length = 8
Y Position
mark
Marker Measurement
Marker Type
You can select the marker type from below.
OFF
The marker is not shown on the display, and you cannot set the marker.
Marker
The position and amplitude of the marker can be displayed.
Marker
Output terminal set
Waveform data file name
Marker position and amplitude (I and Q)
8.5 Eye Display
