8-11
IM 703155-01E
Checking the Output Waveform
8
Setting the Center Frequency of the Horizontal Axis
11.
Press the
Center Frequency [Hz]
soft key.
12.
Enter the center frequency using
numeric keys & ENTER
.
Setting the Horizontal Display Range
11.
Press the
Frequency Span [Hz]
soft key.
12.
Enter the horizontal display range (the range of frequencies to be displayed
between the left and right edges of the waveform display frame with the center
frequency at the center of the waveform display frame) using
numeric keys &
ENTER
.
Executing the Auto Scale of the Horizontal Axis
11.
Press the
Frequency Auto Scale
soft key. Auto scale is executed.
The horizontal scale is set so that the result of the spectrum computation fits on the
waveform display frame.
Marker Measurement
8.
Press the
Marker
soft key. The Marker menu appears.
Selecting the Marker Type
9.
Press the
Type
soft key. Possible choices are displayed.
10.
Use
rotary knob & SELECT
to select OFF or Marker.
• If you select OFF, the marker is not shown on the display, and you cannot set
the marker.
• If you select Marker, proceed to step 11 below.
Executing Marker Measurement
11.
Press the
Position
soft key.
12.
Enter the marker position using the
numeric keys & ENTER
. The position and
voltage (or power) level of the marker are displayed.
For the setup procedures on the Configure menu, see section 8.6.
8.2 Spectrum Display
