6-2
<Operation>
IM 01W06F02-01EN
6.2 Zero Point Adjustment
IMPORTANT
Do not remove the XS110A and XS550 after performing a zero point
adjustment. Powering off within 30 seconds of performing this procedure
will return the zero point to its previous setting.
When the input sensor is set, the adjustment amount of the zero point
is automatically calculated based on the value obtained at the time of
shipment from the factory. Return to the state.
When preparation for starting operation is completed, zero point adjustment
is performed as necessary. Adjust the zero point while the input to the sensor
is stable. For how to adjust the zero point, refer to the Sushi Sensor Series
Software Edition (IM01W06C01-01EN). When zero point adjustment is
completed, the motor is already in operation.
6.3 Start of operation
Confirm that installation, wiring, network settings and operation of the product
are correct before starting operation.
6.4 Operation stoppage
To stop operation, remove XS110A or set XS550 to OFF mode.
NOTE
• Refer to the XS110A User’s Manual (IM01W06D01-01EN) for how to
remove the battery.
• When storing the XS110A with the battery installed, it is recommended
to set this product to OFF mode to prevent battery exhaustion. To
change to OFF mode, refer to Sushi Sensor Series Software Edition
(IM01W06C01-01EN).
