15 ·
YZ-114 PLUS
· 14
YZ-114 PLUS
SYSTEM SETTINGS
The profile is being saved.
Once the profile is saved, the memory will show the battery type and
number of cells.
For the selected profile, the battery type and cell count will be
displayed, followed by the charge and discharge currents. These two
indications will be cycled.
Use the
＋/－
buttons to select another profile.
To load a memory profile, select the profile to load and then press the
ENTER button for 3 seconds.
The profile will be read from memory.
To start charging/discharging with the profile loaded from memory,
press the START button for 3 seconds.
When the charger is turned on for the first time, the system will be configured with default values
for each of the settings. The System Settings menu will show the settings in the order shown in
the below table, and can be changed as needed.
The setting can be changed by pressing the ENTER button on the setting to be changed. While
the value is blinking, the value can be changed by pressing the
＋/－
buttons and can be
confirmed by pressing the ENTER button one more time.
S a f e t y T i m e r
O N 1 2 0 M i n
R e s t T i m e
C H G > D C H G 1 0 M i n
C a p a c i t y C u t - O f f
O N 5 0 0 0 m A H
T e m p e r a t u r e U n i t
C e l s i u s
T e m p C u t - O f f
O N 5 0 C 1 2 2 F
This value sets the maximum charge time for
the safety timer. When the charging process
starts the safety timer will engage, and if the
charge time exceeds this time, the charge
process will automatically stop. This is
intended to prevent overcharging the battery,
however, it should be set long enough to
prevent premature termination before the full
charge of the battery.
OFF/
ON
(100-50000 mAh)
Menu
Values
Description
OFF/
ON
(
1-720 Min)
OFF/
ON
(20 C/68 F -
80 C/176 F)
Celsius
Fahrenheit
1-60Min
The temperature display can be switched
between Celsiusor Fahrenheit.
GETTING STARTED
This value sets the maximum capacity the
battery will be charged before the safety
features stops the charge process.
If the delta peak voltage is not detected nor
the safety timer has not yet stopped the
charge process, this feature will stop charging
if more than the specified charge capacity has
been reached.
While charging, the battery temperature will
rise. If the battery temperature (as detected by
the external temperature probe, part No. YZ-
114P-2) reaches this temperature the charge
process will automatically stop.
Time interval to allow the battery to cool
between the charge/discharge cycles.
