-11-
●
Elimination of drain
Before starting work in the morning and afternoon, elimi-
nate drain from the drain tank. Before use, purge air
through the air hose to eliminate drain from the air hose,
and then connect the air hose to the pneumatic tool.
●
Use this pneumatic tool at proper air pressure.
Using the pneumatic tool at air pressure over the specified
air pressure could result in damage to it or accidents. To
avoid that, be sure to mount a pressure gauge and a
reducing valve and use the pneumatic tool at proper air
pressure (dynamic air pressure with the gauge of air
piping at free speed). As the setting method of air pres-
sure,
adjust the regulator on the air piping, running the
tool without any tip tool at free speed.
※
Refer to the page 20 on the specified air pressure.
●
Supply clean and dry compressed air.
Since dust or drain could result in malfunctions of the
pneumatic tool or accidents, supply clean and dry com-
pressed air to it. For that purpose, it is recommended to
install an air drier, air filter, etc.
●
Use proper air hose.
Use an oil-resistant air hose with abrasion-resistant exter-
nal surface and suitable for operating air pressure for the
specified inside diameter. In addition, do not use a deterio-
rated or excessively-long air hose (recommended length: 5
meters at maximum).
●
Use the proper peripheral equipment and accessories
Use the proper tip tool such as socket, bit, drill, grinding
wheel, chisel, needles etc., for the power tool.
And when you are not sure about the usage of peripheral
equipment and accessories (sockets, bits and couplers),
please consult us or your dealer before using them.
■
Working environment:
●
Provide adequate lighting for the workplace and keep
it clean at all times.
Dark or messy workplace could result in accidents. To
avoid that, pay careful attention to lighting and make
efforts to keep the workplace clean and tidy.
CAUTION
CAUTION
CAUTION
WARNING
WARNING
WARNING
Summary of Contents for YX-1100
