III. Installation Instruction
1. Install Batteries
Slide the batteries chamber’s cover in the
direction of the arrow.
Insert the batteries according to the label inside
battery chamber.
Make sure the direction of the batteries’ polarity
is correct. Close the battery chamber cover in
the direction of the arrow.
2. Mount the speedlite on your camera
Loosen the locking ring by turning it in the
direction of the arrow. Slip the speedlite hot shoe stand into the
camera hot shoe stand until it stops. Turn the locking ring in the
direction of the arrow tighten. To detach the speedlite, loosen the
locking ring by turning it in the opposite direction.
IV. Basic Functions
1. Basic Operations
Operation of the buttons
：
Component Operation
[Power Button]
Power switch of the flash light. The power
of the flash light can be opened or closed
by pressing this button for 2 seconds. It is
suggested that the battery shall be taken
out after the power of the flash light is
turned off through this button.
[Mode Switch
Button]
The mode of the flash light will be switched
among the TTL/M/Multi/S1/S2 in circle for
each press.
[Test Button]
Press the test and the flash will output the
brightness.
[
＋
]and[
－
]button
Under the TTL mode, the exposure
compensation can be adjusted through this
button (the flash compensation of the
camera will be covered)
Summary of Contents for Speedlite YN468-II
Page 1: ...USER MANUAL ...
