TX
RX
RX
RX
MASTER
SLAVE
SLAVE
SLAVE
Transmission
distance
Approx.
100m
Wireless flash shooting: Radio transmission
When YN860Li is used as master unit, it can remotely alter flash mode,
output, stroboscopic times, stroboscopic frequency and focal length of
YN860Li/YN660/YN560IV/YN560III/YN968N which are set to slave unit
mode, it can control slave unit parameters of 6 groups at most, it is also
compatible with RF605,RF603(II),RF-602 series wireless flash trigger.
When YN860Li is used as slave unit, it supports receiving signals from the
following master control unit: YN860Li/YN560IV/YN660 speedlite, and
YN560-TX(II)/RF605/RF603(II)/RF-602 series wireless flash trigger.
Master unit refers speedlite or wireless flash trigger installed on camera,
slave unit refers to speedlite or wireless flash trigger controlled through
radio transmission. For using accessary small bracket to fix slave unit, the
basic relative position and operating range are as shown in the figure.
-12-
Radio Transmission Master Control Unit Setting
Short press the
[ ]
on the speedlite until
[ ]
displays , the flash is
set to be master control unit.
Long press the
[ ]
button, the channel sign flickers, the speedlite
supports 16 channels, Press [up] [down] [left] [right] button for setting
and press
[
OK] to save.
