Injury Hazard
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts or bruises.
NOTE : Do not scrape the bowl while the stand mixer is operating.
The bowl and beater are designed to provide thorough mixing without frequent scraping. Scraping the bowl
once or twice during mixing is usually suffi cient. Turn the stand mixer off before scraping.
The stand mixer may warm up during use. Under heavy load with extended mixing time, you may not be able
to comfortably touch the top of the stand mixer. This is normal.
T E C H N I C A L I N f O R M A T I O N
Voltage/frequency : 220—240V - 50/60Hz (1200W)
Agitator kettle capacity : 5,5 liters
B E f O R E f I R S T U S E
All parts of the stand mixer are to be thoroughly cleaned before being used for the first time. (see
•
section: Cleaning).
Take out the required length of cable from the cable tidy on the base of the blender and connect the
•
device to the mains supply.
A D J U S T I N G T H E H E I G H T O f Y O U R A T T A C H M E N T S
( S e e f i g u r e A )
Your attachments are equipped with a system for adjusting the height above the bottom of the bowl for
optimum results.
Press the release button (2) lift the multifunction head and insert the mixer blade, dough hook or
1.
whisk.
Hold it in position.
2.
Lower the head of the appliance (10) with the button (2) press until a click is heard.
3.
Adjust the height by turning the shaft: adjust the accessories to the ideal position.
4.
Lift the head (10) of the appliance again, hold the Mixer blade, Hook or whisk in position.
5.
Before using for the first time, clean all parts of the accessories with soapy water .rinse and dry.
6.
Place the appliance on a flat, clean and dry surface and then plug in your appliance.
7.
WARNING
