15. Activating impulse mode
16. Programming key-ring remotes
6
1. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from programming
mode without saving any changes.
2. To reverse this procedure please repeat the instruction.
Blind will make up/down
movement. Motor will
make a sound.
Press programming
button P2 on any
remote control.
Press
DOWN button.
Blind will make
up/down movement.
Motor will make a few
short sounds.
When motor is in
impulse mode single push of
a button on the remote will
cause motor to make
short move.
Press
UP button.
Blind will make up/down
movement. Motor will
make a sound.
1. When programming key-ring remotes that do not have additional P2 programming button the same function is substituted with
simultaneous push of STOP and UP buttons.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from programming
mode without saving any changes.
Blind will make up/down
movement. Motor will
make a sound.
Blind will make up/down
movement. Motor will
make a sound.
Blind will make
up/down movement.
Motor will make a few
short sounds.
Motor will
make a sound.
Press
UP button.
Press simultaneously
STOP and UP
programming buttons.
Press simultaneously
STOP and UP
programming buttons.
Press and hold
for about 2 seconds
programming button
on the motor head.
