4. Connection
5. Range
3
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence
(SEP - Association of Polish Electrical Engineers) or equal license. Device is designed to operate in places shielded from
unfavourable weather conditions. Motor should be installed in accordance with all provisions of regional law and professional
standards. All cables connecting power receiver with electric source should be protected from overload and short-circuits
effects with devices automatically disconnecting power. Device should be powered with a separate source and protected
only with a fast-blow fuse (never slow-blow fuse). Creating electrical system using inadequate fuse may result in loosing
rights under the provisions of warranty. When connecting device to power source with cables with adequate cross-section
should be used. Long-lasting output load capacity table should be the ground for choosing adequate cables.
230 V AC
phase wire
neutral wire
protective wire
L
N
brown wire - phase
black wire - impulse switch
white wire - impulse switch
Mounting power supply wire,
antenna and microswitch.
230 V / 50 Hz
yellow-green wire - protective
blue wire - neutral
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
230 V / 50 Hz
200 m
35 m
433,92 MHz
L1
outdoor
L2
indoor
Operating
frequency
20
Roller shutter with remotely controlled motor
L2
L1
1
3
2
L1
L3
L2
