6. Programming first transmitter
4
1. Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
2. If the end positions are not set, the programming of the first transmitter results in the deleting of pre-programmed
transmitters from memory.
1. If the end positions are not set, the motor is in pulse mode.
2. Longer than 2 minutes pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
7. Changing motors direction
8. Programming limit positions
METHOD 1:
Changing the work motor direction using this method is only possible before the limit positions are programmed.
METHOD 2:
UPPER LIMIT POSITION:
Turn on power supply
or press programming
button on motors head
(for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Press STOP button
for a 2 seconds
on the remote.
Press and hold
programming button for
6 seconds on motor head.
Roller shutter will make short
up/down movements.
Motor will make 2 short sounds.
Roller shutters
will make 2 short
up/down movements.
Motor will make
several sounds.
When pressing DOWN
button roller shutter moves up.
Simultaneously
press and hold
UP and DOWN buttons
for 2 seconds.
Roller shutter
will make short
up/down movements.
When pressing DOWN button
roller shutter moves down.
Press
UP button
We stop the motor
in the upper limit position.
Roller shutters will make
2 short up/down
movements. Motor will
make several sounds.
Simultaneously
press and hold UP and STOP
buttons for 2 seconds to
confirm upper limit position.
LOWER LIMIT POSITION:
Roller shutters will
make 2 short up/down
movements. Motor will
make several sounds.
Press
DOWN button.
We stop the motor
in the lower limit position.
Simultaneously
press and hold DOWN
and STOP buttons for
2 seconds to confirm
lower limit position.
