6. Programming first transmitter
3
II MODE - STABLE SWITCH FOR BLINDS:
a) A short circuit between wires 1 and 3 causes open the curtain.
b) A short circuit between wires 1 and 4 closes the curtain.
1. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
III MODE - ASTABLE SWITCH:
a) A short circuit between wires 1 and 3 causes open.
b) A short circuit between wires 1 and 4 closes the curtain.
c) A short circuit between wires 1,3 and 4 stops the curtain.
IV MODE - IMPULSE SWITCH
a) A short circuit between wires 1 and 3 causes to move the curtain in step-by-step mode.
Press and hold the programming
button on the motor for 5
seconds. Release programming
button after the second flash
of the diode.
Press programming button P2
on the remote control.
Press and hold the programming
button on the motor
for 5 seconds. The LED diode
flashes 5 times - settings have
been saved.
Press and hold the programming
button on the motor for 5
seconds. Release programming
button after the second flash
of the diode.
Press two times programming
button P2 on the remote control.
Press and hold the programming
button on the motor
for 5 seconds. The LED diode
flashes 5 times - settings have
been saved.
Press and hold the programming
button on the motor for 5
seconds. Release programming
button after the second flash
of the diode.
Press three times programming
button P2 on the remote control.
Press and hold the programming
button on the motor for 5
seconds. The LED diode flashes
5 times - settings have been
saved.
Press and hold the programming
button on the motor for 5
seconds. Release programming
button after the second flash
of the diode.
Press four times programming
button P2 on the remote control.
Press and hold the programming
button on the motor for 5
seconds. The LED diode flashes
5 times - settings have been
saved.
Switch power on.
Press
programming button
P2 on the remote control.
Press
programming button
P2 on the remote control.
The led diode
will flash once.
The led diode
will flash once.
Press OPEN button
on the remote control.
The LED diode flashes 5 times -
transmitter has been
programmed.
5
5
5
5
5
