1. We mount the handles. Two handles per meter
of curtain track, and one for each following meter of curtain track.
3. Mount the motor in the holder, then move the protection
until it snaps into the motor.
2. Place the curtain track on the handles.
3. Installation
4. Battery charging
5. Connecting and configurating of the switch.
2
1. Connect the swich to the socket using the RJ plug. For mounting the RJ plug, use the right tools for it.
2. The motor can work in one of four switch modes:
I MODE - ASTABLE SWITCH FOR BLINDS
a) A short circuit between wires 1 and 3 causes open or stop the curtain.
b) A short circuit between wires 1 and 4 closes or stops the curtain.
1. Use only the dedicated charger for the device. Using another charger may damage the motor.
2. Charg the battery at least once every 6 months.
3. It is recommended to charge the battery for min. 6 hours.
4. Ensure that the motor is fully charged before the first start-up.
Connect the motor
to the charger.
When charging the battery,
the LED diode lights up red.
When the battery is charged,
the LED diode lights up green.
Press and hold the programming
button on the motor for
5 seconds. Release programming
button after the second flash
of the diode.
Press programming button P2
on the remote control.
Press and hold the programming
button on the motor
for 5 seconds. The LED diode
flashes 5 times - settings have
been saved.
4
3
2
1
close
open
common wire
1
4
