York Fitness 52024, Instruction Manual

6 •   YORK Diamond X400 X-Trainer  

| INSTRUCTION MANUAL

ASSEMBLY INSTRUCTIONS

Getting Started

Place all parts from the box in a cleared area and position 

them on the floor in front of you. Remove all packing 

materials from your area and place them back into the box. 

Do not dispose of the packing materials until assembly 

is completed. Read each step carefully before beginning. 

If you are missing a part, please contact our technical 

support. 
After unpacking the unit, open the hardware bag and make 

sure that you have all the following items. 

Some hardware 

may be already attached to the part:

Hardware Identification Chart

This chart is provided to help identify the hardware used 

in the assembly process. Place the washers, the end of 

the bolts, or screws on the circles to check for the correct 

diameter. Use the small scale to check the length of the 

bolts and screws.

NOTE: The length of all bolts and screws except those 

with flat heads is 

measured from below 

the head to the end of 

the bolt or screw. Flat 

head bolts and screws 

are measured from 

the top of the head to 

the end of the bolt or 

screw.

No. 87 

TOOL (M6 X 105L - BK)

No. 88 

TOOL (M6 X 99L - BK)

No. 148 

TOOL (M5 X 70L - BK)

No. 89 

TOOL (10 X 13 X 14 X 15)

Part No. 138 x 8

ALLEN HEAD SCREW (M8 X 58)

Part No. 45 x 6

ALLEN HEAD SCREW (M8 X 15)

Part No. 44 x 8

ALLEN HEAD SCREW (M8 X 20)

Part No. 42 x 4

ALLEN HEAD SCREW (M8 X 25)

Part No. 40 x 2

ALLEN HEAD SCREW (M8 X 70)

Part No. 69 x 8

SPRING WASHER (M5) 

Part No. 67 x 36

SPRING WASHER (M8)

Part No. 65 x 8

WASHER (M5 X Ø19 X 1.5T)

Part No. 61 x 32

WASHER (M8 X Ø16 X 1.2T)

Part No. 60 x 4

WASHER (M8 X Ø38 X 2.0T)

Part No. 74 x 6

NYLOC NUT (M8)

Part No. 50 x 8

SCREW (M8 X 18)

Part No. 56 x 2

SCREW (M5 X 35L)

Part No. 137 x 4

SCREW (M5 X 12MM)

Part No. 147 x 4

SCREW (M5 X 10MM)

Part No. 51 x 12

SCREW (M5 X 12)

Part No. 48 x 2

SCREW (M4 X 15MM)

Part No. 47 x 8

SCREW (M5 X 15MM)