5. Attach the handlebars
1. Open the handlebar clamp bracket and
place the handlebar inside
2. Close the clamp bracket and place the
rear handlebar bracket cover over it
3. Secure in place using the Multi-position
Handle and screws as shown
4. Turn the handlebars to the fully upright
position
5. Connect the 2 sets of wires together and
then push them down into the inside of
the front post - through the narrow gap
behind the rubber stop
6. attach the front handlebar bracket cover
as shown
7. Attach the 2 elbow supports with the 2
screws as shown
FIXINGS:
FIXINGS:
x 2
Part
No.
40
4. Attach the console to the handlebars
1. Push the console wires through the
square hole
2. Secure the console onto
the bracket using screws
as shown
(Screw are located in the
back of the console)
FIXINGS:
FIXINGS:
x 4
Part
No.
27
x 1
Part
No.
42
8
27
40
42
35
40
x 1
Part
No.
35
Make sure the handlebars are
fastened securely in place with the
multi-position handle
!
41
x 2
Part
No.
41
90
