SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
INSTRUCTION
18
Insert ball end of
HIGH/LOW PULLEY CABLE
(118) end
pointing upwards) into
ROTATING PULLEY BRACKET
(36)
and mount
PULLEY WHEEL
(113) in front using the bolt, washers,
nut and plastic caps as illustrated.
Feed other end of
HIGH/LOW PULLEY CABLE
(118)
through front of slot in bottom of
HIGH/LOW SUPPORT TUBE
(33)
and fix
PULLEY WHEEL
(84) with
PULLEY COVERS
(85)
above cable using nut, washers, bolt and spacers as illustrated.
Attach 4 x
PULLEY WHEELS
(84) to
HIGH/LOW CROSS SUPPORT
(35)
using bolts, washers, nuts and plastic caps as illustrated.
Feed
HIGH/LOW PULLEY CABLE
(118) up rear
and from outside pass over rear
PULLEY WHEEL
(84) at top of
HIGH/LOW SUPPORT TUBE
(33), over the second
rear
PULLEY WHEEL
(84) before passing under
HIGH/LOW SUPPORT TUBE
(33).
Loop
HIGH/LOW PULLEY CABLE
(118) back up
over the near side front
PULLEY WHEEL
(84) followed
by the outside
PULLEY WHEEL
(84), then down and mount
the cable end inside the small bracket at top of
PULLEY GLIDE BRACKET
(34) using bolt,
washers and nut as illustrated.
Now mount
PULLEY WHEEL
(84) with
2 x
PULLEY COVERS
(85) above the loop of
cable under
HIGH/LOW CROSS SUPPORT
(35)
and pass one end of
SINGLE PULLEY BRACKET
(39)
either side from under
HIGH/LOW PULLEY CABLE
(118)
and attach using nut, bolt and washers as illustrated.
10.5mm X 23mm
X 2mm
FLAT WASHER X
8
M10 NYLON
LOCKNUT X
5
68
70
M10 X 50mm HEX HEAD BOLT X
2
58
M10 X 65mm HEX HEAD BOLT X
1
M10 X 125mm HEX HEAD BOLT
X
2
57
47
17 X 17 X 44mm
PLASTIC END CAP X
4
101
10.5
mm
X 23mm
X 2mm
CURVE WASHER X
2
72
PULLEY WHEEL
SPACER X
2
112
M8 X 37mm HEX HEAD BOLT X
1
8.5mm X 20mm X 2mm
WASHER X
2
61
73
M8 NYLON
LOCKNUT X
1
66
YORK G570 / 20
17mm X 17mm
PLASTIC END CAP X
2
103