SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
*
*
1.
2.
3.
ERROR 1 CODE
This is a safety feature that can stop the treadmill from functioning. This error can occur
because the computer is not receiving the correct information from the speed sensor located
near the motor. As a precaution the computer stops the treadmill until it begins to receive
the correct feedback.
By performing a few simple checks, the error can be cleared quickly and easily,
and the treadmill can be ready for use.
The treadmill does not
move and displays
“
ERROR 1
”
Switch off the treadmill at
the mains, and then switch
it on again.
If
“
ERROR 1
”
still shows
switch off and push the
running mat round
(1 cycle) using your feet.
Then switch back on.
If
“
ERROR 1
”
still shows,
then UNPLUG from the
mains and check all of the
wire connections made
during the assembly.
(SEE BOLD PRINT)
UNPLUG
If the treadmill still does
not move, then please
contact the helpdesk.
Doing this may reset the
program error, and the treadmill
will be ready to use.
This should reset the sensor,
and the treadmill will be ready
to use.
Once the cables have been
checked, turn on the treadmill
again. This should eradicate
the problem.
When assembling, there are several cables that need to be connected.
It is very common for these cables to look like they are connected
when they are in fact not fully connected.
Make sure that these cables are connected as tightly as possible.
The connections may have come apart whilst assembling the treadmill.
When assembling, there are several cables that need to be connected.
It is very common for these cables to look like they are connected
when they are in fact not fully connected.
Make sure that these cables are connected as tightly as possible.
The connections may have come apart whilst assembling the treadmill.
YORK T275 TM / 22
