Pulse
cannot be
detected
The induction wire is not
connected correctly or broken
Check and reconnect the wire correctly or change it
Console line fault
Change the console
Console
display
incomplete
Screw too loose
Tighten the screw
System defective
Change the console
Treadmill folding and moving
1. Folding
(1) Cut off the power before folding the treadmill.
(2) Check if the incline is in the lowest position.
(3) Lift up the treadmill to the upright position, the E-
zfit linking part will automatically stuck in the
cylinder, as shown in the picture.
Picture 1
2. Unfolding
1. To unfold the treadmill, choose a place about 1
meter from the power socket and the ground is flat
without other obstacles.
2. When unfolding the treadmill, user should hold the
running desk with both hands and step on the anti-
reverse tube. The treadmill will drop to the ground
slowly. At this point user must be about 1 meter
away from the treadmill, until the treadmill is fully
unfolded, as shown in picture 2.
3. When moving the treadmill, the followings must be
determined:
(1) the power has been switched off;
(2) the power plug has been pulled off from the
socket;
(3) the main frame has been folded;
After the above points are confirmed, the machine can
be moved slowly by holding the end of the running
desk with one hand and the handle bar on the same
side with the other hand, as shown in the picture 3.
Anti-reverse
tube
Cylinder
Wheels
Picture 2
