10
AYK550-UH User’s Manual
Installation
Connection Diagrams
The layout of connection terminals is similar for all frame sizes (R1
…
R6). The only
significant layout difference is in the power and ground terminals for frame sizes R5
and R6. The following diagrams show:
• Terminal layout for frame size R3, which, in general, applies to all frame sizes
except as noted above.
• Power and ground terminal layout for frame sizes R5 and R6.
Warning! For floating (ungrounded) networks remove screws at EM1 and EM3.
Panel Connector
Power LED (Green)
Fault LED (Red)
Optional Module 1
X1 – Communications
Optional Module 2
GND
Power Output to Motor
Power Input
EM1
J1 – DIP Switches
X1 – Analog Inputs and Outputs
X1 – Digital Inputs
X1 – Relay Outputs
for Analog Inputs
J1
AI1: (in Voltage Position)
AI2: (in Current Position)
ON
ON
(and 10 V Ref. Voltage Output)
(and 24 V Aux. Voltage Output)
EM3
PE
(U1, V1, W1)
(U2, V2, W2)
X0003
(RS485)
R5/R6 differ.
See next page.
Frame Sizes
R1…R4
(Diagram shows the R3 frame.)
J2 – DIP Switches
J2
ON
off position
on position
for RS485 Termination
J2
ON
Terminals Not Used
Summary of Contents for AYK 550
Page 256: ...D1 AYK550 UH User s Manual Appendix D Appendix D Base Drive Drawing 205662 Drawings Fig 1...
Page 257: ...AYK550 UH User s Manual D2 Appendix D Base Drive w Fused Disconnect Drawing 205648 Fig 2...
Page 258: ...D3 AYK550 UH User s Manual Appendix D Base Drive w Non Fused Disconnect Drawing 205647 Fig 3...
