YORK INTERNATIONAL
2
This equipment is a relatively complicated apparatus.
During installation, operation, maintenance or service,
individuals may be exposed to certain components or
conditions including, but not limited to: refrigerants, oils,
materials under pressure, rotating components, and both
high and low voltage. Each of these items has the po-
tential, if misused or handled improperly, to cause bodily
injury or death. It is the obligation and responsibility of
operating/service personnel to identify and recognize
these inherent hazards, protect themselves, and proceed
safely in completing their tasks. Failure to comply with
any of these requirements could result in serious dam-
age to the equipment and the property in which it is
IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
situated, as well as severe personal injury or death to
themselves and people at the site.
This document is intended for use by owner-authorized
operating/service personnel. It is expected that this indi-
vidual possesses independent training that will enable
them to perform their assigned tasks properly and safely.
It is essential that, prior to performing any task on this
equipment, this individual shall have read and understood
this document and any referenced materials. This indi-
vidual shall also be familiar with and comply with all
applicable governmental standards and regulations per-
taining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION identifies a hazard which
could lead to damage to the machine,
damage to other equipment and/or en-
vironmental pollution. Usually an in-
struction will be given, together with
a brief explanation.
NOTE is used to highlight additional
information which may be helpful to
you.
DANGER indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri-
ous injury.
WARNING indicates a potentially
hazardous situation which, if not
avoided, could result in death or seri-
ous injury.
External wiring, unless specified as an optional connection in the manufacturer’s product
line, is NOT to be connected inside the micro panel cabinet. Devices such as relays, switches,
transducers and controls may NOT be installed inside the micro panel. NO external wiring
is allowed to be run through the micro panel. All wiring must be in accordance with YORK’s
published specifications and must be performed ONLY by qualified YORK personnel. YORK
will not be responsible for damages/problems resulting from improper connections to the
controls or application of improper control signals. Failure to follow this will void the
manufacturer’s warranty and cause serious damage to property or injury to persons.
