10
Meridian
Systems
Zoning Design Guide
036-21478-001 Rev. A (0802)
This is a summary of the key items you need to con-
sider for the design and layout of a successful zoning
system.
It is important that you study the design guide for a
more in depth understanding of proper system design.
By following the design guide and these tips you can
eliminate many unnecessary headaches that occur when
the basic rules of zoning are not followed. Always con-
tact your York applications group if you have any ques-
tions.
•
Always group zones with similar load
profiles on the same HVAC unit.
•
Never mix perimeter zones with interior
zones on the same HVAC unit.
•
Each zoned HVAC unit should have a
minimum of 3 to 4 zones. Any less and you
should consult the factory.
•
Each zoned HVAC unit can support a
maximum of 16 voting zones. Any more
zones and you should contact the factory.
•
When using auxiliary heat for individual
zones, perimeter heat such as baseboard is
always preferred and more economical to
operate than a fan terminal unit with reheat.
•
If you have electric reheat coils mounted on
VAV boxes, it is recommended that a fan
powered box be used. Consult the factory for
further details concerning this application.
•
If there is an economizer on the HVAC unit,
it is highly recommended, though not
required, that the Zone Manager control the
economizer.
•
Pressure Independent Zones must always use
round dampers or VAV boxes, never
rectangular - no exceptions!
•
Never attempt to use a zone control system
on a true VAV application. See “ Zoning
Systems Versus True VAV Systems” on page
9 of this guide for detailed information.
•
Bypass dampers should always be sized for
60%-70% of the HVAC units rated CFM.
•
Even though the Meridian
system has
certain features to help protect your
equipment, never override or disconnect any
safety devices associated with the HVAC
unit.
Basics of Designing A Zoning System
Summary of Contents for Meridian
Page 4: ......
