70
YORK INTERNATIONAL
7:
Lead Compr 2 Stages Loading,
Lag Compr 1 Stage Loading
8:
Lead Compr 2 Stages Loading,
Lag Compr 2 Stages Loading
9:
Lead Compr 3 Stages Loading,
Lag Compr 2 Stages Loading
10:
Lead Compr 3 Stages Loading,
Lag Compr 3 Stages Loading
This message provides a real time display of the aver-
age rate of change of leaving chilled water as seen by
the micro. A (-) or (+) sign is also shown to indicate a
temperature fall or a temperature rise.
This message informs the operator which system is in
the lead.
This message informs the operator that the micro has
commanded the auxiliary contacts (optional) for the
chilled water pump to close.
This message informs the operator that the micro senses
the outdoor ambient temperature is below 40°F (4.4°C)
and is commanding the Evaporator Heater to turn on.
Once turned on, the heater will turn off at 45°F (7.2°C).
This message informs the operator that the micro has
commanded the auxiliary contacts (optional) for the con-
denser water pump to close.
“OFF”: SYS 1 Liquid Line Solenoid De-energized
(Closed).
“ON”:
SYS 1 Liquid Line Solenoid Energized (Open).
S Y S
2
S T A G E S
O F
L O A D I N G
1
S Y S
2
F O R W A R D
F A N S
S T A T U S
O F F
S Y S
2
R E V E R S E
F A N
S T A T U S
O F F
T E M P E R A T U R E
R A T E
–
1 . 5
D E G F / M I N
L E A D
S Y S T E M
I S
S Y S T E M
N U M B E R
1
E V A P O R A T O R
W A T E R
P U M P
S T A T U S
O N
E V A P O R A T O R
H E A T E R
S T A T U S
O F F
C O N D E N S E R
W A T E R
P U M P
S T A T U S
O F F
S Y S
1
L I Q U I D
L I N E
S O L E N O I D
S T A T U S
O F F
S Y S
1
S T A G E S
O F
L O A D I N G
2
S Y S
1
F O R W A R D
F A N S
S T A T U S
O N
S Y S
1
R E V E R S E
F A N
S T A T U S
O F F
S Y S
1
H O T
G A S
B Y P A S S
V A L V E
S T A T U S
O F F
S Y S
1
R U N
T I M E
2 0 0
S E C S
S Y S
2
L I Q U I D
L I N E
S O L E N O I D
S T A T U S
O F F
This message informs the operator of the number of
stages of loading which are active on SYS 1.
This message informs the operator of the number of for-
ward running fans which are active on SYS 1.
This message informs the operator whether the revers-
ing fan is active on SYS 1.
This message informs the operator whether the Hot Gas
Solenoid is ON or OFF. The micro will activate the Hot
Gas signal regardless of whether or not this option is
installed.
The Run Time for SYS 1 since the last start is displayed.
“OFF”: Sys 2 Liquid Line Solenoid De-energized
(Closed).
“ON”:
Sys 2 Liquid Line Solenoid Energized (Open).
This message informs the operator of the number of
stages of loading which are active on SYS 2.
This message informs the operator of the number of for-
ward running fans which are active on SYS 2.
This message informs the operator whether the revers-
ing fan is active on SYS 2.
Summary of Contents for Millennium YCAJ150
