York PACER 3503, Instruction Manual

 SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY. 

*

*

PACER 3503 / 18

TROUBLE SHOOTING

WHEN TO CALL FOR HELP

This treadmill is designed with user safety as the number one priority.   In the event of an electrical

failure, the treadmill will shut off automatically to prevent user injury and to prevent damage to 

expensive components such as the motor.

When you encounter unusual behaviour from the treadmill, simply turn the power switch off and on

to reset the treadmill.

This should clear incidental errors and prepare the treadmill for normal operation again.

If, after you have reset the treadmill by turning the power switch off and on again, the treadmill is 

still not operational, then it is time to call the helpline.

NO SIGNAL ON THE CONSOLE LCD WINDOWS

If there is no signal on the monitor, even after you have switched the treadmill off and on again to 

reset, check the communication cable between monitor and motor controller.

First, make sure the connections are good and that the cable is not pinched or damaged.

If defective, ask your dealer for a replacement cable.

Error 1: Speed sensor error

                Error 1 occurs when the console is not picking up the motor speed signal.

                In other words, when the motor speed is not correctly fed back to the controller 

console, the treadmill will shut off to protect the user and error 1 will be displayed 

                on the console.

                When trouble shooting this error, do not stand on the running mat.

                When you report error 1 to the service center, make sure you note down 

                the circumstantial details.

                1. Is the motor operational?    For example, if the motor is not working when you push

                    the start button, error 1 displays immediately.

                    Motor and running mat do not move.

                2. If the treadmill was running, then it stopped and showed error 1, 

                    then the motor is operational.

                3. If the motor is operational, did the  treadmill stop at low speeds 

                   ( 1.0 - 1.5 KPH ) or high speeds ( 10 KPH - 12 KPH )

and 

MONITOR POWER SUPPLY

The training computer does not require any battery since it is supplied with power via the 

running treadmill.

PROTECTIVE CIRCUIT

To protect your safety, this treadmill is designed and equipped with run away protection.

If the admissible operating speed of the treadmill is exceeded or fallen below, the protective 

circuit will shut off the treadmill to protect you and the equipment.  The treadmill will flicker all 

display values to alert the user to the condition.  Reset the treadmill by turning the power switch 

on/off to return the treadmill back to the normal operating mode.