0171-971
4
It is recommended to tighten the screws pos. 167 one at a time so that the shaft seal is not
damaged due to uneven tightening. Tighten the screws to the torques indicated in the
In-
struction Manual.
S
Mount the oil splash ring pos. 162. Fit the coupling for the motor as described in the
In-
struction Manual
and turn the compressor shaft manually to check that it is able to rotate
without hindrance.
Dismantling of Shaft Seal and Internal Oil Seal Set
The dismantling is carried out in reverse order compared to the description above. However,
please note the following:
S
To be able to dismount the rotating part of the shaft seal, it is necessary to dismantle the
slide ring pos. 156C by dismounting the screws pos. 156I. Now it is possible to loosen
the three pointed screws pos. 160E (see the
Instruction Manual)
and pull out the rotating
part of the shaft seal.
S
The retaining ring pos. 156E can be pulled out through the two M6 threaded holes in the
end surface.
S
The balance piston pos. 156B can be pulled out by means of the two threaded pins no.
3 from the tool set. The pins can be mounted in two of the M6 holes in which the screws
pos. 156K are usually mounted.
YORK REFRIGERATION
Chr. X’s Vej 201
·
P.O. Box 1810
·
DK-8270 Højbjerg
·
Denmark
Phone +45 87 36 70 00
·
Fax +45 87 36 77 05
