JOHNSON CONTROLS
100
FORM 102.20-N1
ISSUE DATE: 7/06/2016
SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
3. Using a moderate amount of pressure, force the
latch over the third knockout as shown in
FIGURE 153 -
CORRECTLY INSTALLED LATCH PIN
(P/N 026-35788-604)
LD10496
4. Grasp the loose end of the latch, and place it over
the pre-filter frame, so that the latch secures the
pre-filter to the SH filter.
5. Repeat the process with the remaining latches.
6.
The filters should now be securely installed into
FIGURE 154 -
CORRECTLY INSTALLED
CARTRIDGE WITH PLEATS
LD10160
Installing a Multi-Cell SBM Double Headered
(DH) Filter
Use the following instructions to install a Multi-Cell
SBM double header (DH) filter (nominal 12 in.) into a
16 g galvanized holding frame with four latches (P/N
026-35788-612), as shown in
1. Install the two latches on each side of the frame.
not on the top or bottom. Refer to the sets of
that should
be used for the latches.
FIGURE 155 -
CORRECT USE OF KNOCKOUTS
LD10150
2. Insert the straight end of the latch between the two
knockouts furthest from the corner.
3. Using a moderate amount of pressure, force the
latch over the third knockout
.
4. The latch installation should be complete. The
latch should now be trapped within the three
knockouts
.
5. Repeat the steps with the remaining latches. Note
the orientation of the latch to the knockouts as
shown in
.
FIGURE 156 -
CORRECT LATCHOUT/KNOCKOUT
CONFIGURATION
LD10154
6. After the latches are installed, the frame should be
configured as shown in
which shows there are two latches per side, none
on the top or bottom.
