JOHNSON CONTROLS
98
FORM 102.20-N1
ISSUE DATE: 7/06/2016
SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
Filter Installation
Installing a 2 in. Pleated Filter
Use the following instructions to install a 2 in. Multi-
Pleat Elite filter into a 16 g galvanized holding frame
with four latches (P/N 026-35788-702), as shown in
1. Install one latch at each corner (4 corners) of the
frame. The latch fits into two rows of three knock
-
outs. Use the row of knockouts closest to the gas-
ket for nominal 1 in. filters or filters with a 13/16
in. single header. Use the second set of knockouts
for nominal 2 in. filters.
2. Insert the straight end of the latch between the two
knockouts furthest from the corner.
3. Using a moderate amount of pressure, force the
latch over the third knockout. The latch should
now be trapped within the three knockouts, but
should be able to freely rotate as shown in
4. The latch installation should be complete.
FIGURE 148 -
CORRECTLY INSTALLED LATCH PIN
(P/N 026-35788-702)
LD10171
5. Install the other three latches into the corners.
6. Rotate all of the latches outward, and insert the
filter into the frame.
7. Grasp the circular end of the latch, and rotate it
across the corner of the filter.
8.
Push the end of the latch towards the filter until the
latch catches beneath the knockout on the frame.
9. Repeat the process with the remaining latches.
10.
The filter should now be securely installed into
FIGURE 149 -
FULLY INSTALLED FILTER
LD10174
Installing a 4 in. Pleated Filter
Use the following instructions to install a 4 in Micro-
MAX filter into a 16 g galvanized holding frame with
four latches (P/N 026-35778-604), as shown in
.
1. Install one latch at each corner (4 corners) of the
frame. The latch fits into two rows of three knock
-
outs. Use the row of knockouts closest to the gas-
ket for nominal 1 in. filters or filters with a 13/16
in. single header. Use the second set of knockouts
for nominal 2 in. filters.
1. Insert the straight end of the latch between the two
knockouts furthest from the corner.
2. Using a moderate amount of pressure, force the
latch over the third knockout. The latch should
now be trapped within the three knockouts, but
should be able to freely rotate as shown in
3. The latch installation should now be complete.
FIGURE 150 -
CORRECTLY INSTALLED LATCH PIN
(P/N 026-35788-604)
LD10177
