JOHNSON CONTROLS
102
FORM 102.20-N1
ISSUE DATE: 7/06/2016
SECTION 3 - HANDLING, STORAGE, AND INSTALLATION
LD10184
FIGURE 160 -
SPRING LATCH PULLED AND
FASTENED IN FILTER HOLE
Installing Pre-Filter Latches
1.
To install the pre-filter latches, slide the end of the
latch with a 180° turn over the edge of the header,
as shown in
. Install the
latch at the approximate midpoint of the filter leg.
The pre-filter latch should be slid over the header
.
FIGURE 161 -
INSTALLING PRE-FILTER LATCH
LD10163
2.
Repeat the steps for the remaining pre-filter
latches.
3.
Place the pre-filter against the face of the Multi-
Cell SBM DH filter. The pre-filter latches may
have to be re-positioned as shown in
, to allow the proper placement of
the pre-filter.
FIGURE 162 -
POSITION PRE-FILTER IN FRONT
OF FINAL FILTER
LD10165
4.
Grasp the end of the pre-filter latch and spring
it, so that it fits over the edge of the pre-filter
as
shown in
.
5. Repeat this step with the remaining latches.
FIGURE 163 -
SPRING END OF LATCH
After placing all remaining pre-filter latches around
the pre-filter; the finished assembly should look like
.
FIGURE 164 -
COMPLETED ASSEMBLY
LD10167
LD10190
