FORM 155.32-ICOM2.EN.UL
SECTION 3 - HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
ISSUE DATE:1/10/2018
JOHNSON CONTROLS
25
When jacking the machine, be sure to fit the jack in each of the jack-up supports as shown below.
Figure 6 -
Jack-up Procedure
Use the jack-up support on the main shell of the body as shown below. If using a high temperature generator, use secondary
jack-up support.
Operate the front and rear jacks alternately.
Do not jack up the machine more than about 20 mm at a time. Each time the machine is jacked up, adhere it with a suitable
crosstie.
Figure 7 -
Jack-Up Support
LD22944
Reinforcement
Jack-up Support
High Temperature
Generator
Jack-up Support
Jack
Machine Legs
LD22935
Jack-up Support
Jack-up Support