FORM 155.32-ICOM2.EN.UL
SECTION 6 – OPERATION
ISSUE DATE:1/10/2018
JOHNSON CONTROLS
107
The Chilled/Hot water section of the screen shows you the following information:
Inlet Temperature:
temperature of the hot or chilled water measured as it enters the
evaporator
Outlet Temp.:
temperature of the chilled/hot water measured as it leaves the evaporator
The Cooling Water section shows you:
Inlet Temperature:
temperature of the cooling water measured as it enters the absorber.
Outlet Temp.:
temperature of the cooling water measured as it leaves the condenser.
Refrigerant Temp.:
temperature of the refrigerant in the evaporator.
Absorber Temp.:
temperature of the diluted solution in the absorber
Exhaust G Temp.:
temperature of the exhaust gas measured as it leaves the high
temperature generator
HG Temperature:
temperature of the concentrated solution in the high temperature
generator
HG Pressure:
pressure in the high temperature generator
HG Concentration:
concentration of the concentrated solution in the high temperature
generator
Control Valve:
percentage that the valve is open
There are two sets of buttons on the right side of the screen. The first set gives you access
to information about past occurrences. For instance, if you press the
3 times ago
button,
you will see the settings as they appeared 3 events ago. You can see up to 6 past events.
The buttons in the History Menu section allow you to move between the various screens:
Hourly Operation:
Press this button to access the Hourly Operation History screen.
Minutely Operation:
Press to view the Minutely Operation History screen.
Failure History:
Press this button to see the Failure History screen.
Alarm History:
Press to see the Alarm History screen.
To move to another screen, press the any of the available buttons along the bottom of the
screen.
