EFFECTS LOOP
The
EFFECTS LOOP
can be used to insert signals from external sources such as a Digital
Effects Unit or Equalizer into the signal path. The loop is inserted after the tone and vol-
ume controls. To use the
EFFECTS LOOP
connect the
EFX SEND
jack to the input of the
equalizer or effects unit. Connect the output of the equalizer or effects unit to the
EFX
RTN
jack to complete the loop.
LINKING TOGETHER MULTIPLE WEDGES
When the
Yorkville 50KB/KW
is used with a line level input for stage monitor purposes,
it’s possible to link together several units by using the inputs on
Channel 2
. Insert the
mixed signal from a mixing console into either of the two phone jacks (on
Channel 2
). It
is possible to use the remaining phone jack input on
Channel 2
as an output to link to
another
Yorkville 50KB/KW
.
Please note: that only information being sent to the input of Channel 2 will be linked.
PHONES
Headphones can be connected to the
Yorkville 50KB/KW
by inserting a headphone plug
into the
PHONES
jack located on the front panel. While headphones are connected, the
internal speaker is disconnected. Always use stereo headphones. The audio heard
through stereo headphones will be a mono signal separated into the two earpieces.
Caution: Always exercise caution when using headphones to avoid permanent hearing loss.
POWER SWITCH
When the
Yorkville 50KB/KW
is turned on, the
LED
beside the power switch will be
illuminated.
2
SPECIFICATIONS
Jack Config
Sensitivity
Channel 1 Input one XLR jack
<3 mVrms
one phone jack
<10 mVrms
Channel 2 Input two phone jack
<100 mVrms
two RCA jacks
<100 mVrms
Effects Send phone jack
1 Vrms
Effects Return phone jack
1 Vrms
Speaker Components
Woofer
10", 4-Ohm, 50 Watt
Tweeter 3.75", 8-Ohm
Power Rating >70W, 4-Ohm load, 1 KHz, 2 cycle burst
>50W, 4-Ohm load, 1 KHz, continuous at 5% THD
* Measurements made with regulated power supply
Construction 7-Ply Poplar Plywood with internal bracing
Exterior Finish Blue/black carpet with plastic corners
Dimensions 50KB: 15.5"x11.9"x16" (HWD)
40cm x 30cm x 41cm (HWD)
50KW: 18.5"x16"x15.5" (HWD)
47cm x 41cm x 40cm (HWD)
Power Requirements 120V AC 60Hz 0.3A
230V AC 50Hz 0.15A