PCB NO: M1081 - 1.10
FILE NAME: M1081.CDR
NOTE
SOME OF THESE ILLUSTRATIONS DO NOT NECESSARILY AFFECT
BOARD ASSEMBLY, BUT WIRING INSTEAD
NOTE:
THIS IS NOT A COMPONENT LAYOUT AND SHOULD NOT BE USED AS ONE
MODEL(S) AFFECTED:
DESIGN BY: IERYMENKO/ATTWOOD
DRAWN BY: A. POLLARD
DATE: OCT 13, 1993
PRODUCTION LAYOUT VERSION NO: 1.00
Yorkville
YORKVILLE SOUND
550 GRANITE COURT
PICKERING, ONTARIO, CANADA, L1W 3Y8
PHONE: 905-837-8481 FAX: 905-837-8746
SOLDERSIDE M1081-1.00
L
L
R
R
SOL
S DE M1081-00
DER I
1
1
1
1
1
1
1
1
AFTER SOLDERING
BREAK AWAY BOARDS AS REQUIRED
PUT RIBBON CABLE INTO STRAIN
RELIEF’S AS SHOWN
MOLEX CABLES
CHECK THAT THE ORIENTATION IS CORRECT
MAKE SURE THAT CABLE IS PUT IN STRAIGHT
BEND OVER THE TWO OUTSIDE LEGS, CHECKING
THAT THEY DONT SHORT TO ANOTHER TRACE
TRIM ALL OTHER LEGS
ALL THERMISTORS (1-7) MUST BE
PUSHED AWAY FROM JACKS. IN
OTHER WORDS, THEY MUST STAND
UP STRAIGHT
1
2
3
4
6
7
5
(THEY HAVE BEEN LABELLED ACCORDINGLY)
AFTER SOLDERING
BREAK AWAY BOARD
ADD RTV SILICONE BETWEEN RIBBON
CABLE AND PCB.
DO NOT PUT CABLE INTO STRAIN RELIEF
RIBBON CABLE MUST BE FLAT AS POSSIBLE
TO THE PCB
NOTE
CHECK THAT JACK IS MOUNTED
FLAT ON THE PCB.
BEND A LEG OVER ON EITHER
SIDE TO HOLD THE JACK IN PLACE
WHEN BENDING THE LEG MAKE
SURE IT IS NOT SHORTING
TO ANOTHER TRACE
BEND OVER THE TWO
OUTSIDE LEGS TO HOLD
JACK IN PLACE
THE CENTER LEG IS TO BE TRIMMED
