1
YX SERIES
YX10SP
10-Inch Active Subwoofer
Introduction
The Yorkville Sound YX10SP offers one of the best values for a 10-inch active subwoofer. Created
as an easy-to-setup addition to any P.A., the YX10SP will extend the bass of a typical sound system
with the least amount of complication.
Configuration
The YX10SP can be used in several different configurations. The basic system setup is a single
YX10SP used with a pair of full-range loudspeakers, typically Yorkville Sound YX15Ps. Multiple
YX10SPs can be used along with multiple full-range enclosures if more bass is required. The YX10SP
accepts both mono and stereo sources. The stereo signals will be properly combined into mono.
Multiple YX10SPs can be daisy chained through the Link jacks while full-range loudspeakers can
be properly fed a filtered signal from the High Pass Output jacks.
1. YX10SP Level Control
The YX10SP Level control sets the amount of bass added to the sound system by the YX10SP. This
adjusts for the relative sensitivity of the companion full-range speakers and the desired system
frequency response. This control should be set by listening while operating at a medium level (i.e.
before the onset of limiting) and then not changed. It is not possible to set this control properly at
high levels since the limiter will be determining the output level.
A setting of 0 dB on the YX10SP Level control is the correct starting point when setting up
a sound system. From there, adjustments can be made for the best sound. The 0 dB mark
refers to the setting that will give full power when the line input is used and the input signal
is at a level of +4 dBV.
2. Input Jacks
Use the input jacks to feed the YX10SP with a mono or stereo from your source. It is preferred
that your source go directly to the YX10SP and then be looped up to your full-range
loudspeakers through the High Pass Output jacks.
For mono signals, the Left/Mono jack can use a cable with a ¼-inch or XLR connector. When
using stereo signals, the YX10SP will sum the Left and Right signals internally.
Note: stereo separation is maintained for signals leaving the Link and High Pass Output jacks.
CAUTION:
REPLACE
WITH SAME TYPE
FUSE AND RATING
Power
Power
Level
Activity
/ Limit
Ground
GND
Lift
Left/Mono
Right
Input
Max
0
- 00
dB
Left
Right
Link
Left/Mono
Right
High Pass Output
80Hz
THIS UNIT MUST BE GROUNDED!
CET APPAREIL DOIT ETRE MIS Á TERRE!
MODEL TYPE: YS2009
A-YX10SP / 1v3
Summary of Contents for YX10SP
Page 9: ...7 YX SERIES...
