1. Remove passenger seat.
2. Locate and disconnect license plate light and
turn signal connectors.
3. While securely supporting the stock fender
assembly, remove the four bolts securing the
fender assembly to the subframe. Carefully
remove the stock fender assembly making sure
not to damage connectors in the process.
4. Remove left and right turn signals from the
stock fender assembly.
5. Cut the stock license plate light connector from
the stock fender assembly. Be sure to cut at
least a 6” section of wire from the connector.
Removal
Installation
1. Install (No. 2)
070BG-LH-K1,
license plate light
onto (No. 1)
12551-FEBKT,
fender eliminator
bracket using (No. 9)
M4X6BHS,
4mm screws.
2. Using the
BN-SSS-22-18
butt connectors
provided in the kit, connect the Yoshimura
license plate light wires to the stock license
plate light wires as follows:
Red -to- Orange
Black -to- Green
a) Strip the stock fender light wire ends
1/4” - 1/2” and insert into
BN-SSS-22-18,
butt connectors provided in the kit.
b) Center the spliced wire ends in the
middle and using a heatgun or lighter,
apply heat evenly on the outer edges of
the butt connector to shrink and hold
wires in place.
c) Making sure that the stripped ends are
centered, heat the center of the butt
connector evenly until the solder begins
to liquify.
d) Allow to cool completely and tug both
ends of the wires to verify that connection
is secured.
Scan for link to butt connector instruction video
3. Secure and install (No. 1)
12551-FEBKT,
fender
eliminator bracket to subframe using (No. 6)
M6X20BHS,
6mm button head screws from
below and install (No. 10,11)
6MMWASHER
and
6MMLN,
6mm washer and nut from above
as shown.
4. Install stock rear turn signals onto (No. 4,5)
122000-TSB-L/R,
left and right turn signal
brackets using the stock hardware.
5. Install (No. 4,5)
12200-TSB-L/R,
left and right
turn signal brackets and (No. 3)
070BG-LPF
,
license plate frame to (No. 1)
12551-FEBKT,
fender eliminator bracket using the (No. 7,8)
M6X16BHS
and
M6X14BHS
, 6mm button head
screws and (No. 10,11)
6MMWASHER,
6MMLN,
washer and nut as shown.
6. Route license plate light and turn signal wires
through the hole in (No. 1)
12551-FEBKT,
fender eliminator bracket and through the lower
rear cowl. Re-connect license plate light and
turn signal connectors.
7. Use the cable ties supplied in the kit to secure
license plate light and turn signal wires.
8. Re-install passenger seat.
3
9
1
2
3
8
5
10
11
1
4
7
6
10
11
1
