5. Torque the four clamp base bolts to 10 Nm.
Note: There should be no gaps between clamp base and
upper clamp as shown.
6. Torque the two forward clamp bolts to 5 Nm.
7. Check to make sure all components are secure prior to
riding.
2
Installation
1. Clean handlebar.
2. Grease 6mm x 16mm bolts and install clamp base directly
to front fork. Do not torque at this time.
3. Grease 6mm x 35mm bolts and install handlebar and
upper clamps. Do not torque at this time.
4. Grease 5mm x 12mm bolts and hand tight forward clamp
bolts to desired handlebar alignment. Do not torque at this
time. Leave minimum 2mm gap as shown.
Left
Right
M6X35TP
M6X16TP
M5X12TP
Leave at least
2mm gap