76
ADM_5_9801_[XXPD]
XX: Bit Rate: 00=19200, 01=38400, 12=1200, 24=2400, 48=4800, 96=9600 bps.
P: Parity check: 0= none, 1= odd, 2= even.
D: Data bits: 7= 7 bits, 8= 8 bits.
XXPD= empty (default): Bit rate= 9,600 bps; Parity Check= none; Data bits= 8 bits.
Line Number of L1 Port / EXTN Field Width
ADM_5_9802_[XX0Y]
XX: 00~92= the line number that indicates the L1 port
Y: 1~9= the number of bytes of the EXTN field width
The line number of L1 port must equal to the last two digits of the port number of the extension
port connecting to the L1 port of the EVM. The Line number of L1 port plus one is regarded as
the Line number of L2 port, and so on. Therefore, the port numbers of the extension ports
connecting to EVM must be consecutive.
The EXTN Field width must equal to the longest digit-length of the internal phone numbers.
The Ending Character and Beginning Character
ADM_5_9803_(HexHex)
HexHex: the Hex value(s) with which every incoming character string ends
If this setting is empty, “ETX (03)” will be regarded as the ending character.
ADM_5_9804_(HexHex)
HexHex: the Hex value(s) with which every incoming character string begins.
“CR (0D)” is an incorrect value.
1
st
EXTN Field, Type Field and LN Field
ADM_5_9808_[XX]#
XX: 02~99= the sequence number of the byte of the start of the EXTN field accompanying the
1
st
Type Field
ADM_5_9809_[XXYY]
XX: 02~99= the sequence number of the byte of the start of 1
st
Type Field. For example, “02”
means the 2
nd
byte.
YY: 02~99= the sequence number of the byte of the start of the LN field accompanying the 1
st
Type Field
ADM_5_9810 ~ ADM_5_9815 are used to specify the Type Codes, each of which will be
detected at the 1
st
Type Field. Also, ADM_5_9836 and ADM_5_9837 are together used to
specify the DTE Reply Request Code that the PBX emits to request a DTE reply.
The Type Codes Inside 1
st
Type Field
ADM_5_9810_(HexHex)
HexHex: the Hex value of the Type code, which informs the EVM to provide the
