5.6.2.
Replace the gasspring of a comfort legrest
Preparation
1.
Lift the legrest out of the wheelchair.
Procedure
1.
Remove the screws and nuts (B and C).
2.
Remove the old actuator (A) from the
legrest.
3.
Remove the lever block (D) from the
gasspring (A). The lever block is re-used
with the new gasspring.
4.
Put the level block on the new gasspring.
5.
Put the new actuator in the legrest.
6.
Check the functionality of the actuator.
B
A
D
C
5.6.3.
Replace the actuator of the central legrest
Preparation
See section
5.1.
Procedure
1.
Remove the seat cushion for easy access.
2.
Disconnect the actuator cable.
3.
Remove the circlips from the pivot (A).
4.
Remove the screw (B).
5.
Remove the old actuator (C).
6.
Put the new actuator into the wheelchair.
7.
Connect the actuator cable.
8.
Make sure that the actuator cable is
properly arranged. Use tie wraps.
9.
Put the seat cushion in the wheelchair.
10.
Check the functionality of the actuator.
C
B
A
Maintenance tasks & adjustments
Service manual - Luca
27