4 - 3
Function Code Transmit
When this selection is enabled and function codes are contained within the scanned data, the scanner transmits the function
code to the terminal. Charts of these function codes are provided in
.
Default =
Enable.
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly. Intercharacter, interfunction, and intermessage
delays slow the transmission of data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed between the transmission of each
character of scanned data. Scan the
Intercharacter Delay
bar code below, then scan the number of 5ms delays, and the
Save
bar code using the
inside the back cover of this manual.
To remove this delay, scan the
Intercharacter Delay
bar code, then set the number of delays to 0. Scan the
Save
bar code
using the
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed after the transmission of a particular
character of scanned data. Scan the
Delay Length
bar code below, then scan the number of 5ms delays, and the
Save
bar code using the
inside the back cover of this manual.
Clear One Suffix
Clear All Suffixes
* Enable
Disable
1
2
3
4
5
Intercharacter Delay
Prefix
Scanned Data
Suffix
Intercharacter Delay
Summary of Contents for YJ-HF500
