3 - 10
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
inside back cover, then scanning
Save
.
Scanner Time-Out
Scanner Time-Out powers down the scanner after the unit has been idle for the
specified time. To prevent the scanner from powering down, set this time-out to
0, or no timer. Scan
Scanner Time-Out
, then set the time-out by scanning dig-
its (from 0 - 999,999 ms) from the inside back cover, then scanning
Save.
Default = 1 ms.
Centering
Use Centering to narrow the scanner’s field of view to make sure that when the
scanner is hand-held, it reads only those bar codes intended by the user. For
instance, if multiple codes are placed closely together, centering will insure that
only the desired codes are read.
Note: To adjust centering when the scanner is in the stand, see
If a bar code is not touched by a predefined window, it will not be decoded or
output by the scanner. If centering is turned on by scanning
Centering
On
, the
scanner only reads codes that pass through the centering window you specify
using the
Top of Centering Window, Bottom of Centering Window, Left
, and
Right of Centering Window
bar codes.
User-Specified Reread Delay
Scanner Time-Out
Summary of Contents for YJ4600
