youngmangroup.com
Step 1: To Install the Loft Ladder
Swivel Arm
1.4.
Place the Right Swivel arm in
position on the Right Mounting bracket
and align their holes, Fig 1.4.
1.5.
From the outer edge, guide the
Hinged swivel pin through the arm and
bracket holes and push in completely,
Fig 1.5.
Repeat this procedure with the Left
Swivel arm and the Left mounting
bracket using the other Hinged
swivel pin.
1.6.
The installation will now be at the
stage shown in Fig 1.6.
Attaching the Springs
1.7.
Slide the Ladder sub-frame carrier
bar into the hole in one of the
sub-frame carrier tubes, see Fig 1.7.
Now slide the two spring eyelets onto
the bar.
1.8.
Slide the other end of the carrier
bar into the corresponding hole on the
other sub-carrier tube, Fig 1.8.
There is groove near each end of the
bar for the purpose of holding the
spring in place when installed, see
Fig 1.8 (inset). Locate each spring in
these grooves.
1.5
1.6
1.7
1.8
1.4
Sub-Frame Carrier Tube
Sub-Frame Carrier Bar
8
