Remote-Pager Learn Routine
24
23
In the case of propane gas powered vehicles, there is a risk of left over gas
(anywhere between the gas tank and the engine cylinder) freezing during winter.
Therefore, it needs to burn the left over gas completely before the engine is
turned off.
▶
1
How to burn the left over gas completely.
●
1-1
Automatic Transmission Vehicle Shuts off the Gas Valve switch before turn off
the ignition so that the left over gas in the system burnt completely. Then, turn off the
ignition and take the key out.
●
1-2
Manual transmissisn vehicle or turbo mode of the automatic transmission
vehicle. In the case of the manual transmission vehicle or turbo mode of the automatic
transmission vehicle, turn off the ignition first, shut off gas valve switch and then get out
of the vehicle and close the door. The engine will shut off upon the left over gas has
been completely burnt.
▶
2
In the case of the manual transmission vehicle or turbo mode of the automatic
transmission vehicle, if you do not shut off the gas valve switch there will be left over gas in
the system after the engine is shut off 4 minutes running after door closing. And this left gas
will be refrigerated at winter, so you have to shut off gas valve switch like above 1-2.
▶
3
Driving in short distance after remote-start for a gas powered vehicel
After the remote-start, if you drive the vehicle for less than 4 minutes and 20seconds, the
engine will continue running for 4 minutes and 20 seconds, that is because of the gas option,
that shuts off the gas valve in 20 seconds and shuts off the ignition in 4 minutes after the door
opening after remote start.
So in the case of Manual Transmission Vehicle, the system can not beentered to reservation
mode in this 4minutes and 20 seconds period.
If you replace or add additional remotes, you can program up to three remotes,
please perform the following procedure:
Step1 :
Activate Valet/Programming mode by manually turning the
ignitionn on and off five times
(between Acc and On)
with car
key within a 10 second period.
The parking light will flash once with
successful completion of this step.
Step2 :
Within a 10 second period after cycling the ignition for the 5
th
time, press button
I
.
The car parking lights will flash once to
confirm that the transmitter has been programmed. Continue
program the additional remotes. The parking lights will flash two
times when the programming mode is expired.
Propane gas powered vehicles
4minutes 50seconds
The system wait
Stop of running
Remote
Running
Ignition
Lock
20sec.
30sec.
4minutes
Shut off the
GAS valve
End of
Remote running
Opening
The door
All manuals and user guides at all-guides.com
