Youshiko YC9386, User Manual

11

3. Press again to activate alarm with ice-alert function.

4. To disable the alarm, press until the alarm icon disappears.

RC on 

ALARM off 

ALARM with ice-alert

ALARM on  

TO SET THE ALARM TIME

1. Press and hold the 

[ ALARM ] 

button   for 2 seconds to enter alarm setting mode 

HOUR

 will 

    begin to flash.

2. Use 

[   ] 

button / 

[   ] 

button to adjust

 HOUR

, and press the

[ ALARM ] 

button   to proceed 

    to set 

MINUTE

.

3. Repeat 2 above to set 

MINUTE

, and then press the 

[ ALARM ] 

button   to exit.

Note: 

Pressing the

[ ALARM ] 

button    twice when alarm time is being displayed will activate the 

          temperature-adjusted pre-alarm.

          The alarm will sound 30 minutes earlier if it detects outside temperature is below -3°C.

WEATHER FORECAST                                                                                                                      

The device contains sensitive pressure sensor built-in with sophisticated and proven software that 

predicts weather for the next 12 ~ 24 hours within a 30 to 50 km (19-31 miles) radius.

 Sunny/Clear

Cloudy

Rainy

Rainy/Stormy

Snowy

Slightly Cloudy

Note:

 1. The accuracy of a general pressure-based weather forecast is about 70% to 75%.

          2. The weather forecast is meant for the next 12 hours, it may not necessarily reflect the 

              current situation.

          3. The icon " 

 "  will flash on display when the rainstorm comes.

          4. The 

SNOWY

 weather forecast is not based on the atmospheric pressure, but based on 

               the outdoor temperature. When the outdoor temperature is below -3°C (26°F), the

               SNOWY

 weather indicator will be displayed on the LCD.

BAROMETRIC/ATMOSPHERIC PRESSURE                                                                                        

TO SELECT THE DISPLAY MODE

Press and hold the 

[ BARO ] 

button 

 for 2 seconds to toggle between:

• 

ABSOLUTE

   the absolute atmospheric pressure of your location

• 

RELATIVE    

 the relative atmospheric pressure based on the sea

TO SET RELATIVE ATMOSPHERIC PRESSURE VALUE

1. Press and hold the 

[ BARO ] 

button    for 2 seconds until 

ABSOLUTE

 or 

RELATIVE

 icon 

    flashes.

2. Press 

[   ] 

button / 

[   ] 

button to switch to 

RELATIVE

 mode.

3. Press the 

[ BARO ] 

button    once again until the 

RELATIVE

 atmospheric pressure digit  flashes.

4. Press 

[   ] 

button / 

[   ] 

button to change the value.

5. Press the 

[ BARO ] 

button    to save and exit the setting mode.

Note:

 1. The default relative atmospheric pressure value is 1013 hPa (29.91 inHg), which