15
Note:
1. The unit will automatically exit setting mode in 5 seconds if no button is pressed.
2. When ALERT alarm is on, the area and type of alarm that triggered the alarm will be
flashing and the alarm will sound for 2 minutes.
3. To silence the Alert alarm beeping, press the
[ ALARM ]
button , or let the beeping
alarm automatically turn off after 2 minutes.
WIRELESS SIGNAL RECEPTION
Signal searching Strong signal
Weak signal
Signal lost
No sensor
The 5-IN-1 sensor is capable of transmitting data wirelessly over an approximate operating of
150m range (line of sight).
Occasionally, due to intermittent physical obstructions or other environmental interference, the
signal may be weaken or lost.
In the case that the sensor signal is lost completely, you will need to relocate the Display main unit
or the wireless 5-IN-1 sensor.
TEMPERATURE & HUMIDITY
COMFORT INDICATION
The comfort indication is a pictorial indication based on indoor air temperature and humidity in an
attempt to determine comfort level.
Too cold/too dry
Comfortable
Too warm/too humid
Note:
1. Comfort indication can vary under the same temperature, depending on the humidity.
2. There is no comfort Indication when temperature is below 0°C(32°F) or over 60°C (140°F).
DATA CLEARING
During installation of the wireless 5-IN-1 sensor, the sensors were likely to be triggered, resulting
in erroneous rainfall and wind measurements. After the installation, user may clear out all the
erroneous data from the Display Main Unit, without needing to reset the clock and re-establish
pairing. Simply press and hold the
[ HISTORY ]
button for 10 seconds. This will clear out any data
recorded before.
POINTING 5-IN-1 SENSOR TO THE SOUTH
The outdoor 5-IN-1 sensor is calibrated to be pointing to North by default. However, in some
cases, users may wish to install the product with the arrow pointing towards the South:
