9
Insert required batteries in outdoor sensor , Further connect the main display unit with power
supply then press reset button on both units.
After this weather station will connect with outdoor sensor and with radio control signal
automatically, You don’t need to do anything further, Radio control will connect with in few mins to
few hours and some time can take up to 24h.
Keep the indoor main display unit well away , about 1.5 meter from computers, Wifi Hub, Tv and
Mobile phones etc to avoid interference.
Once indoor main display unit is connected, with outdoor sensor then install the sensor outside, at
a suitable location and insert back up battery in the main indoor display unit.
DISPLAY MAIN UNIT
POWER UP THE MAIN UNIT
1. Plug the power adaptor to power up the main unit.
2. Once the main unit power up,all the segments of the LCD will be shown briefly before entering
the radio-controlled time reception mode.
3. The RC clock will automatically start scanning for the radio-controlled time signal in 8 seconds.
INSTALLATION THE BACKUP BATTERY
1. Remove the battery door of the main unit.
2. Insert a new button cell battery.
3. Replace the battery door.
Note:
1. If no display appears on the LCD after you plug the adaptor, press
[ RESET ]
button by
using a pointed object.
2. In some cases, you may not receive the signal immediately due to the atmospheric
disturbance.
PAIRING OF WIRELESS 5-IN-1 SENSOR WITH DISPLAY MAIN UNIT
After insertion of batteries, the Display Main Unit will automatically search and connect the
wireless 5-IN-1 sensor (antenna blinking).
Once the connection is successful, antenna mark and readings for outdoor temperature, humidity,
wind speed, wind direction, and rainfall will appear on the display.
CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR
Whenever you changed the batteries of the wireless 5-IN-1 sensor, pairing must be done
manually.
1. Change the batteries to new ones.
2. Press
[ SCAN ]
button.
3. Press
[ RESET
button on the sensor.
Note:
1. Pressing
[ RESET ]
button at bottom of wireless 5-IN-1 sensor will generate a new code for
pairing purpose.
2. Always dispose old batteries in an environmentally safe manner.
