6
BATTERY AND INSTALLATION
Unscrew the battery door at bottom of unit and insert the batteries
according to the +/- polarity indicated.
Screw the battery door compartment on tightly.
NOTE:
1. Ensure the water tight O-ring is properly aligned in place to
ensure water resistant.
2. The red LED will begin flashing every 12 seconds.
ASSEMBLY THE STAND AND POLE
Step 1
Insert the top side of the pole to the square hole of the
weather sensor.
NOTE:
Ensure the pole and sensor's indicator align.
Step 2
Place the nut in the hexagon hole on the sensor, then
insert the screw in other side and tighten it by the screw
driver.
Step 3
Insert the other side of the pole to the square hole of the
plastic stand.
NOTE:
Ensure the pole and stand indicator align.
