7
Step 4
Place the nut in the hexagon hole of the stand, then
insert the screw in other side and then tighten it by the
screw driver.
Install the wireless 5-IN-1 sensor in
an open location with no obstructions
above and around the sensor for
accurate rain and wind measurement.
Install the sensor with the smaller end
facing the North to properly orient the
wind direction vane.
Secure the mounting stand and clamps
(included) to a post or pole, and allow
minimum 1.5m off the ground.
1.5 meter off
the ground
Add rubber
pads before
mount on
the pole
Point to
NORTH
MOUNTING GUIDELINES
1. Install the wireless 5-IN-1 sensor at least 1.5m off the ground for better and more accurate wind
measurements.
2. Choose an open area within 150 meters from the LCD console.
3. Install the wireless 5-IN-1 sensor as level as possible to achieve accurate rain and wind measurements.
4. Mount the wireless 5-IN-1 sensor with the wind meter end pointing to the North to correctly orient direction
of the wind vane.
A. Mounting on pole (Pole Diameter 1"~1.3")
(25~33mm)
B. Mounting on the railing
CONSOLE
BACKUP BATTERY INSTALLATION
1. Remove the battery door on the back side of the console.
2. Insert CR2032 button cell as per the polarity information marked on the battery compartment.
3. Replace the battery door.