6.12.2010
YSOFT SAFEQ® ETHERNET READER – ADMINISTRATORS GUIDE V1.3 [EN]
14/17
6
ETHERNET READER BEEP AND FLASH CODE SEQUENCES
The Ethernet Reader contains status leds that serve for interaction with user. This chapter provides list of beep
and flash code sequences as well as their meanings.
6.1
ETHERNET READER BEEP CODE SEQUENCES
In the following text, the „-“ denotes long beep and „.“ denotes short beep.
-
Card read error. Please try placing the card again or use the different card.
.-
Reader validation failed. Server reports that the terminal is not registered on SafeQ. Please consult
administrator manual.
-.-
User validation failed. User card is not registered in the system.
.--
Received error or warning message from server.
---
Connection to SafeQ server failed.
...-
Hardware configuration damaged, cannot continue in booting.
-..-
Maximum number of update attempts reached but no valid firmware detected.
.-.-
Update of firmware failed.
--.-
Software configuration cannot be saved. Probably faulty onboard eeprom.
..--
Software configuration damaged, loading defaults.
-.--
Maximum number of update attempts reached, resuming normal boot.
.---
Firmware damaged.
----
Network init failed.
-...
No reader connected and reader required for correct functionality.
.-..
Update of firmware failed. Error in server response, SafeQ server is probably not configured correctly.
--..
Update of firmware failed. Cannot connect to SafeQ server.
-...-
Debug mode, not for public release!
6.2
ETHERNET READER FLASH CODE SEQUENCES
This section provides flash code sequences used for interaction with a user.
There are following colors used for icons:
Green - Led is green
Red - Led is red
Orange - Led is orange
